Mitsubishi-electric 1786FD Colour Monitor User Manual

DIAMOND VIEW MONITORSDIAMOND VIEW MONITORSDIAMOND VIEW MONITORSDIAMOND VIEW MONITORS A REGISTERED TRA

2 9Easy to Use On Screen Display The On-Screen Display (OSD) allows you to adjust all settings simply with on-screen menus. 9Power Saving Funct

3 Getting Started Installing the Monitor This monitor is equipped with an autosensing power supply for voltage ranges 100~240V AC, 50~60Hz.

4 Connecting through D-SUB signal connector 1. Make sure that the system power is turned off. 2. Connect the computer end of the D-SUB cable to

5 Adjusting the Monitor A Look at the Control Panel EnterExit1 2 3 4 5 Adjusting the Monitor You

6 Selecting function and making adjustments 1) Contrast hot-key mode 1. Press to enter contrast hot-key mode 2. Press or to adjust the settin

7 Make adjustments 1. In Main Menu: Press or to locate the item you desire to change. 2. Press Enter to go into the Sub Menu.

8 3. Pressor to locate the function item. Then press Enter andor to make the adjustment. Hor. Position Exit : SaveOperationinstr

9 Unbalance: adjusts the pincushion balance if both sides of the display are bowed toward the left or right. Trapezo

10 4. Recall geometry preset setting Locate and press Enter to recall the preset settings. The word “Recall” will keep blinking on the scre

11 )The on-screen menu will automatically disappear after 20-second’s of inactivity. If changes have been made, the monitor will automatically

12 Troubleshooting and Useful Hints Troubleshooting Make sure that your monitor is properly installed if you encounter any trouble using this

13 Need More Help? If your problems remain after checking this manual, please contact your place of purchase or contact: Australia Visit the Mits

14 Specifications Picture Tube Size Type Dot pitch Surface coating 17” (43cm) diagonal Shadow mask flat 0.25mm

Table of Contents Safety Instructions for Display Monitors...ii M

i Copyright Copyright © 2000 Mitsubish Electric Australia Pty. Ltd All rights reserved. No part of this publication may be reproduced, transmitted, t

ii Safety Instructions for Display Monitors 1. The AC plug isolates this equipment from the AC Power supply. 2. Unplug the monitor from the wall o

iii Maintenance ✘ Do not expose the monitor to direct sunlight or heat. ✘ Do not spill liquid onto the monitor. ✘ Do not attempt to open the monit

1 Introduction Unpacking the Package Check following items. If they are missing or damaged, consult your place of purchase immediately. 9