Mitsubishi Electric MSZ-FH50VE - E1 Service Manual download pdf (Page 36)

11-1. MSZ-FH25VE MSZ-FH35VE MSZ-FH50VE

NOTE: Turn OFF power supply before disassembly.

OPERATING PROCEDURE PHOTOS

1. Removing the panel

(1) Remove the horizontal vanes.

(2) Remove the front panel. Remove the screw caps of

the under panel. Remove the screws of the under

panel.

(3) Pull out the right top corner of the right panel and

remove the right panel.

(4) Pull out the left bottom corner of the left panel and

remove the left panel.

(5) Unhook the lower part of the under panel and

remove the under panel.

Photo 1

Photo 2

(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the

locking mechanism.

Slide the sleeve.

Pull the terminal while

pushing the locking

lever.

Hold the sleeve, and

pull out the terminal

slowly.

Connector

Sleeve

Locking lever

<"Terminal with locking mechanism" Detaching points>

The terminal which has the locking mechanism can be detached as shown below.

There are two types (Refer to (1) and (2)) of the terminal with locking mechanism.

The terminal without locking mechanism can be detached by pulling it out.

Check the shape of the terminal before detaching.

DISASSEMBLY INSTRUCTIONS

Front panel

Horizontal vanes

Removal procedure

Unlock

Upper and

lower vanes

Unlock the upper and lower vanes as shown

in using a thin instrument.

Then, remove the horizontal vanes in the

direction of .

Horizontal vanes

Screws of the under panel

Right panel

Under panel

Screws of the panels

Left panel

DISASSEMBLY INSTRUCTIONS

OBH623A

1 2 ... 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Mitsubishi Electric MSZ-FH50VE - E1 Service Manual Page 36

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi Electric MSZ-FH50VE - E1