Mitsubishi Electric PAR-30MAA Installation Manual download pdf (Page 34)

T9901085-1-3 UK Page 34 of 38

access

anel

screw

Remove the air filters from the air inlet grilles by gently prizing

them free as shown. Gently vacuum clean and refit the filters

into the curved air inlet grilles. The filters are durable but may

need to be replaced after a number of service intervals.

To remove the bottom access panel unfasten the access panel

securing screws, one at each end, plus two in the centre

(HP1500 DXE and HP2000 DXE units) and slide the panel out

forwards (see picture).

Vacuum clean and remove any build-up of dust, dirt and debris within the air-curtain,

especially on the fans.

Note: Fan motors are permanently lubricated and require no additional lubrication.

If the Air Curtain has been used in Cooling:-

Remove two screws from each end of the air curtain that

attach the air discharge grille assembly to the unit. Remove

the discharge grille assembly from the unit.

On the HP1500DXE and HP2000DXE air curtains

there is an additional screw at the middle of the grille

that also needs to be removed.

Remove condensate hose from the drain tray outlet pipe,

see picture.

1 2 ... 29 30 31 32 33 34 35 36 37 38

No comments

Mitsubishi Electric PAR-30MAA Installation Manual Page 34