OthersMaintenanceOperationsPreparationsBefore UsingLCD PROJECTORMODELSE1UUser ManualSE1
1918Preparationsp.40Before connection• Read the user manual of the device to connect to the projector.• Some types of computer cannot be used or conne
21Operations20 Turning the power off1Press the ON/STANDBY button.A message appears on the screen, confirming that you wish to shut off the power. Thi
23Operations225Projector placement angle adjustmentsThe placement angle and the height of the projected image can be adjusted by the footadjuster.q Li
25Operations24 Correcting the keystone distortion (Keystone)When the foot adjuster p.23 is used to change theprojection angle, the picture will under
27Operations26 Expanding the picture size (Expand)The image being projected can be expanded.1Press the remote control’s EXPAND button.The expanding
29Operations28You can call up on-screen menus, and conduct a number of adjustments and settings usingthe operation buttons p.16 on the control panel (
31Operations30 The display setting menuUse this menu to set screen display-related items.(Full): Display with LCD panel’s resolution(Thru): Display
33Maintenance32The air filter prevents dust and debris from getting inside the projector. Never run theprojector with the filter removed. It is recomm
35Others343Remove the lamp cover.Loosen the 2 screws, then pull up to thedirection of the arrow with your fingers on thearea shown in the figure to re
37Others36If you think something is wrong, check the followings before contacting customer service.Please see “Trouble indications” p.35 as well.If T
Before Using32IMPORTANT SAFEGUARDSPlease read all these instructions regarding your LCD projector and retain them for futurereference. Follow all warn
39Others38Specifications (Continued) List of supported signals (RGB signals)This projector supports the following RGB signals. Note, however, that de
41Others40 SERIAL terminal● Pin assignment76854321Signal NameRXDCTSDSRGNDRTSReservedTXDGNDPin No.12345678DescriptionReceiving dataConsent to sendData
Before Using54IMPORTANT SAFEGUARDS (Continued)11. Power-cord protectionPower-supply cords should be routed so that they are not likely to be walked o
Before Using76The lamp is designed to project the image on the LCD panels. When the lamp no longerfunctions, replace it with a new one.Caution:• Do no
Before Using98If your line voltage is 220 to 240V, use one of the following types of cable.PlugconfigurationPlug typeAustralian240V10ANorth American24
Before Using1110EXEMPTION CLAUSES• Mitsubishi Corporation bears no responsibility in the case of damages arising fromnatural disaster such as earthqua
Before Using1312OthersTrouble indications ... 35Before calling s
1514Preparations(10)(12) (11)(13)(11)(14)(1)(16)(15) (17)(5)(18)(19)(4) (2)(3) (1)(5) (7)(6)(9)(8)(4)Names of each part on the main unitName : Functio
1716Preparations Operating the remotecontrolPoint the remote control toward theprojector’s infrared remote sensor,and press a button on the remotecon
Comments to this Manuals