EN-1LAN Control Utility User Manual (for XD3500U)ContentsPreparation/SetUp ...2P
EN-101Enter “3” and press the Enter key. 2To enable the e-mail notifi cation function of ProjectorView, enter “1” and press the Enter key. (Default is
EN-111Enter “9” and press the Enter key. 2The setting screen is shaded and the setting is updated.It takes about 10 seconds for the setting to be • up
EN-121Start the Projector-Control Device Installer.Select [Start] - [All Programs] - [Projector] - • [Projector-Control Device Installer] (in the case
EN-135The password input screen appears. Enter the password you set. The default password is admin.• (Note)If you input a wrong password 4 successive
EN-14ProjectorView (continued)VIRTUAL REMOTE controllerPut a checkmark in the box of the Virtual remote enabled on the ProjectorView main screen, and
EN-15Initial settingTo load information on the projector such as model name and lamp operating time, set the projector data in advance. Click the SETU
EN-16Support for the PJLink™ function This projector supports standard protocol PJLink™ for projector control and you can control and monitor projecto
EN-17[Notes on Instant Shut Down]Instant shutdown of the projector during control using the network function may cause ProjectorView to fail to displa
EN-2Preparation/SetUpPreparation before using the network functionThis projector is equipped with the network function to control and monitor the proj
EN-31Copy two fi les (DI_4.1.3.6.msi and Setup.exe) contained in the Tools folder of CD-ROM to the hard disk of your personal computer.2Double-click th
EN-4Preparation/SetUp (continued)4Select a folder to install the program, and click Next. 5Click Next. 6Installation starts.The progress of the instal
EN-51Start the Projector-Control Device Installer.Select [Start] - [All Programs] - [Projector] - • [Projector-Control Device Installer] (in the case
EN-65Select [Obtain an IP address automatically] and click Next. 6Click Next.Check that the options are marked with • checkmarks as shown on the right
EN-75Select [Assign a specifi c IP address] and click Next. 6Enter a fi xed IP address (for example, 192.168.0.1) and click Next. (Note)Do not use 0 or
EN-81Start the Projector-Control Device Installer.Select [Start] - [All Programs] - [Projector] - • [Projector-Control Device Installer] (in the case
EN-91Enter “0” and press the Enter key. 2Input the old (current) password and press the Enter key. (Default password is admin.)If you input a wrong pa
Comments to this Manuals