Mitsubishi Electric MS-GF60VA Operations Instructions Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 29
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
En-3
● OPERATING INSTRUCTIONS ●
• Make sure the polarity of the batteries is correct.
Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Press CLOCK gently using a thin instrument.
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Operation display
section
ON/OFF
(operate/stop)
button
Temperature buttons
Page 4
Operation select
button Page 4
ECONO COOL
button
Page 6
FAN speed
control button
Page 5
Off-timer button Page 6
On-timer button Page 6
VANE control
button Page 5
TIME set buttons Pages 3, 6
Increase time
Decrease time
CLOCK button Page 3
RESET button Page 3
Lid
Slide down
to open
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Installing the remote controller batteries Setting current time
NAME OF EACH PART
PREPARATION BEFORE OPERATION
1.
Press CLOCK.
3.
Press CLOCK again.
2.
Press the TIME buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer).
Remote controller
Outdoor units may be different in appearance.
*1 The manufacturing year and month is indicated on the spec name plate.
WIDE VANE
button Page 5
LONG button Page 5
POWERFUL
COOL
button Page 5
1.
Remove the front lid.
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.
4.
Press RESET.
Air inlet (back and side)
Drainage hose
Air outlet
Drain outlet
Outdoor unit
Indoor unit
Operation indicator lamp
Remote control receiving section
Emergency
operation switch
Page 4
Horizontal vane
Air outlet
Air fi lter
(Nano platinum fi lter)
Air inlet
Heat exchanger
Front panel
Air cleaning fi lter
(Electrostatic anti-allergy
enzyme fi lter, option)
Display section
Refrigerant piping
Spec name plate *1
Spec name plate *1
JG79A935H01_en.indd 3 7/3/2014 4:18:38 PM
Page view 3
1 2 3 4 5 6 7 8 9 ... 28 29

Comments to this Manuals

No comments