A-control Mr. SLIM models located in various places within a building can be connected to "M-NET" so that they can be monitored / contro
The M-NET board ① is installed in the bottom of electric box so that the DIP switches (SW11,SW12) come front. ※Push it firmly until you hear i
Between the outdoor units, it is OK that only M-NET wiring (2 wires, no polarity) is done.The setting should be done by rotary switches SW11 for one fi
(3) Refrigerant address setting In case that the A control Slim is set for group between different refrigerant (when multiple refrigerant syst
103Centralized control remote controllerCentralized control remote controllerCentralized control remote controllerOutdoor unit corresponds to M-NETOut
INSTALLATION MANUAL FOR A-M CONVERTERThis manual is written only for the models SAFETY PRECAUTIONS●After installation, make test operation and confirm
Applicable models(3) Refrigerant address setting In case that the A control Slim is set for group between different refrigerant (when multiple ref
2. Installation procedure 【Applicable model : Group A】 Affix insulation sheets ? and ? ③ to the backside of the flange surface on the top of the side
RG79V300H04 Pate insulation sheet ? ③ on sheet-metal so that it completely envelops the edge surface of sheet-metal. Install M-NET board ① (wi
2. Installation procedure 【Applicable model : Group C】SW12 SW11ABSPosition holeHole for M-NET groundCENTRALIZED CONTROL(M-NET)ABS①M-NET boardAddress s
2. Installation procedure 【Applicable model : Group E】CENTRALIZED CONTROL(M-NET)A B SBG79H744H 02SW12CN2MCNDCN5SW114312⑧Label⑬Ground wireControl board
2. Installation procedure 【Applicable model : Group E】CENTRALIZED CONTROL(M-NET)A B SBG79H744H 02SW12CN2MCNDCN5SW114312⑧Label⑬Ground wireControl board
Install M-NET board ① (with insulation sheets and supports) on the side of electric box .At the four point indicated by arrows. ※Push it firml
Comments to this Manuals