Mitsubishi Electric PC36 Instruction Manual download pdf (Page 13)

1. FUNCTIONS AND CONFIGURATION

1 - 6

(d) Installation of the side cover

Hook of the side cover

1) Insert the side cover setting tabs into the

sockets a) of servo amplifier.

Knob

2) Push the side cover at the supporting point a)

until the knob clicks.

(3) MR-J3-11KT(4) to MR-J3-22KT(4)

CAUTION

Avoid touching any remained burr after cutting off the part a) of the case.

Otherwise, injury may occur.

The installing screw holes for the MR-J3-11KT(4) to MR-J3-22KT(4) are covered at shipping. When

installing the unit for the first time, cut off the part a) of the case after removing the side cover.

When cutting off the part a), avoid damaging the case of the servo amplifier. After cutting off it, inside of

the servo amplifier has been exposed even though the side cover and the unit are installed. Avoid

unwanted parts from entering through the opened area into the servo amplifier. For installing or

removing the unit, refer to (2) in this section. The side cover structure is the same for MR-J3-11KT(4) to

MR-J3-22KT(4) and for this unit. Install or remove the side cover with the same way as for the unit.

However, the installing screw for the side cover is unnecessary.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

No comments

Mitsubishi Electric PC36 Instruction Manual Page 13