Mitsubishi Electric PC36 Instruction Manual download pdf (Page 25)

4. DISPLAY/OPERATING PARTS

4 - 2

4.1.2 Display details

On the servo amplifier display (three-digit, seven-segment display), check the status of communication with

the CC-Link IE controller at power-on, check the station number, and diagnose a fault at occurrence of an

alarm.

The table below shows the details.

Display Status Description

b## CC-Link IE communication

waiting

Power of the servo amplifier was switched on at the condition that the power of the

CC-Link IE master module is off.

CC-Link IE master module is faulty.

(Note 1) d## Ready Servo-on has been performed after initialization, and it is ready for operation. (The

display appears for 2 s.)

(Note 1) C## Not ready Initialization is in progress, or an alarm has occurred.

(Note 2) $$$ Drive enabled The drive enabled condition has lasted for 2 s after turning on RYn1 (servo-on).

(Note 3) A** Alarm/Warning The alarm No./warning No. that occurred is displayed.

888 CPU Error CPU watchdog error has occurred.

(Note 4) b00 JOG operation, positioning operation, program operation, DO forced output, and 1

step feed

(Note 1) d##.

C##.

(Note 4)

Test operation mode

Motor-less operation

Note 1. ## denotes any of symbols or numerals of -- or 00 to C0 and what it means is listed below.

## Description

00 Set to the test operation mode.

-- For the station No. 0 (unset), refer to section 4.1.3.

01 Station No. 1

02 Station No. 2

: :

99 Station No. 99

A0 Station No. 100

: :

A9 Station No. 109

b0 Station No. 110

: :

b9 Station No. 119

c0 Station No. 120

2. $$$ indicates the number of the point table No. being executed. $$$ is a number between 0 and 255.

3. ** indicates the warning/alarm No.

4. MR Configurator/MR Configurator2 or an MR-PRU03 parameter unit is required.

4.1.3 Unspecified station number

If 0 (unspecified) is set as the station number, the communication is performed with the station number set

by the master station.

Servo amplifier

power on

Display

b- - cAO

CC-Link IE communication starts

Station No.100 designated by the master station

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 49 50

Comments to this Manuals

No comments

Mitsubishi Electric PC36 Instruction Manual Page 25

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi Electric PC36