Mitsubishi Electric UD8400U-W User Manual download pdf (Page 6)

EN-6

Preparing your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in

the package.

Cables

Remote control parts

Remote control

(290P188-10)

RS-232C cable

(246C598-20)

R6 (size-AA)

battery (two)

RGB cable for PC

(246C597-20)

Others

• Lens cap (attached to the projector)

• Terminal cover

• Lamp replacement tray

• CD-ROM

• Safety Manual/Quick Start up

• Mitsubishi logo plate

• Control panel label for ceiling installation

• Terminal block label for ceiling installation

Mini D-SUB

15-pin

Mini D-SUB

15-pin

D-SUB

9-pin

Power supply parts

Power cord (two)

(246C684-10, 246C383-20)

• Used for projector control

by computer.

D-SUB

9-pin

Important:

• The attached power cords are to be used exclusively for this product. Never use them for other products.

Inserting the batteries into the remote control

1. Remove the rear lid of the remote control.

2. Check the polarity (+), (-) of the batteries, and set them

correctly, inserting their (-) side ﬁ rst.

• If the battery is inserted from the (+) side ﬁ rst, inserting

the (-) side is difﬁ cult because the coil spring end hits

on the battery side. If the battery is forced to insert in

this way, the outer label of the battery may get ripped

and it may cause a short-circuit and heating.

3. Attach the rear lid.

Important:

• Use two size-AA batteries (R6).

• Replace the 2 batteries with new ones when the remote

control is slow to operate.

Removing the batteries from the remote control

Remove the back lid of the remote control and take out the

batteries.

Caution:

• Use of a battery of wrong type may cause explosion.

• Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

• Dispose of used batteries according to your local regulations.

• Batteries may explode if misused. Do not recharge, disassemble, or dispose of them in ﬁ re.

• Be sure to handle the batteries according to the instructions.

• Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

• Keep batteries out of reach of children and pets.

• Remove the batteries, if the remote control is not used for a long time.

• Do not combine a new battery with an old one.

• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in

contact with your eyes, rinse them with water and then consult your doctor.

1 2 3 4 5 6 7 8 9 10 11 ... 75 76

Comments to this Manuals

No comments

Mitsubishi Electric UD8400U-W User Manual Page 6

Comments to this Manuals

Related products and manuals for Data projectors Mitsubishi Electric UD8400U-W