Mitsubishi Electric F700 Instruction Manual Page 12
- Page / 143
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
7
2
INSTALLATION AND WIRING
Installation of the inverter and instructions
2.3 Installation of the inverter and instructions
• Installation of the Inverter
• Install the inverter under the following conditions.
• The inverter consists of precision mechanical and electronic parts. Never install or handle it in any of the following
conditions as doing so could cause an operation fault or failure.
Installation on the enclosure
30K or less 37K or more
REMARKS
For replacing the cooling fan of the FR-F740-185K or more, 30cm of space is necessary in front of the inverter.
Refer to page 87 for fan replacement.
• Handling of the wiring cover
(FR-F720-18.5K, 22K, FR- F740-22K, 30K)
For the hook of the wiring cover, cut off the
necessary parts using a pair of long-nose pliers etc.
CAUTION
When encasing multiple inverters, install them in parallel
as a cooling measure. Install the inverter vertically.
Refer to the clearances below.
Vertical
Fix six positions for the FR-F740-
185K to 400K and fix eight positions
for the FR-F740-450K to 560K.
ClearancesAmbient temperature and humidity
Measurement
position
Measurement
position
Inverter
Leave enough clearances and take
cooling measures.
55K or less 75K or more
5cm
5cm
5cm
10cm or more
20cm or more
20cm or more
10cm or more
5cm
or more *
5cm
or more *
10cm
or more
10cm
or more
Temperature:
-10°C to 50°C
Ambient humidity:
90% RH maximum
(front)
*1cm or more for 3.7K or less
Clearances (side)
Inverter
5cm
or more
Direct sunlight High temperature,
high humidity
Horizontal placement
Mounting to
combustible material
Oil mist, flammable
gas, corrosive gas,
fluff, dust, etc.
Transportation by
holding the front cover
Vertical mounting
(When installing two or
more inverters, install
them in parallel.)
Vibration(5.9m/s
2
or more*)
* 2.9m/s or more for the
185K or more
2
CAUTION
If you cut off unnecessary parts and no wires are
connected, the protective structure (JEM 1030) of the
inverter becomes open type (IP00).
- INSTRUCTION MANUAL (BASIC) 1
- INVERTER 1
- 4. Additional Instructions 2
- Environment 2
- , surge suppressor or radio 2
- 2 INSTALLATION AND WIRING 2 3
- 3 DRIVE THE MOTOR 28 3
- 4 ADJUSTMENT 51 4
- 5 TROUBLESHOOTING 62 4
- 7 SPECIFICATIONS 91 5
- APPENDICES 110 5
- FR --F740 6
- 2 INSTALLATION AND WIRING 7
- 2.1 Peripheral devices 8
- Peripheral devices 9
- INSTALLATION AND WIRING 10
- •Reinstallation 11
- 2.4 Wiring 13
- 200V class 14
- Screw size 17
- Cable Sizes 19
- (3) Total wiring length 21
- (2) Output signals 23
- (separate power) 25
- (7) Control logic switchover 27
- 2.4.7 RS-485 terminal block 30
- 2.4.8 Communication operation 30
- 3.1 Step of operation 33
- 3.2 Operation panel (FR-DU07) 34
- Operation panel (FR-DU07) 35
- DRIVE THE MOTOR 36
- Operation 37
- 3 Base frequency 39
- (PU operation mode) 40
- Flickering 42
- Operation Display 43
- DisplayOperation 45
- 11. Stop 45
- (external operation) 48
- Three-phase 50
- AC power supply 50
- 10. Stop 51
- 7. Mode/monitor check 51
- 4 ADJUSTMENT 56
- CAUTION 58
- (Pr.7, Pr.8) 59
- ADJUSTMENT 60
- 4.7 Parameter clear 63
- 4.8 All parameter clear 64
- 4.9 Parameter copy 65
- 4.10 Parameter verification 66
- 5.1 List of alarm display 67
- Causes and corrective actions 68
- TROUBLESHOOTING 68
- Inverter 79
- (2) Clearing procedure 81
- 6.1 Inspection Item 84
- Inspection Item 85
- 6.1.6 Cleaning 88
- 6.1.7 Replacement of parts 89
- 6.1.8 Inverter replacement 93
- Earth (ground) terminal 94
- Measuring 95
- 7.1 Rating 96
- •400V class 97
- 7.2 Common specifications 98
- Common specifications 99
- Outline dimension drawings 100
- SPECIFICATIONS 100
- • DC reactor supplied 106
- • FR-F740-250K, 280K, 315K 106
- • FR-F740-400K 108
- • FR-F740-450K 109
- • FR-F740-500K, 560K 110
- • FR-PU04 111
- • FR-F740-185K to 315K 113
- • FR-F740-355K or more 113
- APPENDICES 115
- Extended parameters 117
- Extended parameter list 118
- (2) Wiring instructions 139
- Instructions for installation 140
- (1) EMC Directive 142
- (2) Low Voltage Directive 142
- Print Date 143
- Manual Number 143
- Revision 143
Related products and manuals for Power adapters & inverters Mitsubishi Electric F700
(59 pages)© 2020, manymanuals.com. All rights reserved. | 1.320 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals