Mitsubishi Electric F700 Instruction Manual download pdf (Page 47)

Operation by the start command from

the operation panel (PU operation mode)

REMARKS

Pr. 184 AU terminal function selection must be set to "4" (AU signal) (initial value). (Refer to the Instruction Manual (applied).)

Change the frequency (60Hz) at the maximum value of potentiometer (at 20mA)

Adjust the frequency in Pr. 126 Terminal 4 frequency setting gain frequency. (Refer to page 50.)

Change the frequency (0Hz) at the minimum value of potentiometer (at 4mA)

Adjust the frequency in calibration parameter C5 Terminal 4 frequency setting bias frequency. (Refer to

the Instruction Manual (applied).)

Stop

Flickering

DisplayOperation

10.

Deceleration

Perform 4mA input.

The frequency value on the indication

decreases according to Pr. 8 Deceleration time

until 0.00Hz is displayed and the operation

status indication of FWD or REV flickers.

The motor stops.

11.

Stop

Press .

FWD or REV of the operation status indication

turns off.

Output of the

adjustment meter

(4 to 20mADC)

Output of the

adjustment meter

(4 to 20mADC)

Acceleration → constant speed

Perform 20mA input.

The frequency value on the indication increases

according to Pr. 7 Acceleration time until 60.00Hz

is displayed.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 142 143

No comments

Mitsubishi Electric F700 Instruction Manual Page 47