Mitsubishi Electric F700 Instruction Manual download pdf (Page 41)

Operation by the start command from

the operation panel (PU operation mode)

3.5.2 Use the setting dial like a potentiometer to perform operation.

POINT

Set "0" (extended mode parameter valid) in Pr. 160 User group read selection.

Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.

Operation example Change the frequency from 0Hz to 60Hz during operation

REMARKS

· If flickering "60.00" turns to "0.0", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".

· Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning .

· Pr. 161 will not be displayed when simple mode (Pr. 160 User group read selection="9999") is selected. (Refer to page 51 )

The frequency flickers for about 5s.

DisplayOperation

Flicker ··· Parameter setting complete!!

PU indication is lit.

Flicker ··· Parameter setting complete!!

Turn until (

Pr. 160) appears.

5. Press to read the currently set value.

" " (initial value) appears.

Turn counterclockwise to change it to

the setting value of " ".

7. Press to set.

8. Change Pr. 161 to the setting value of " "

in the similar manner.

(Refer to step 4 to 7.)

9. Mode/monitor check

Press twice to choose

monitor/frequency monitor.

10. Press (or ) to start the inverter.

The parameter number

previously read appears.

1. Screen at powering on

The monitor display appears.

2. Press to choose the PU operation

mode.

3. Press to choose the parameter

setting mode.

11. Turn clockwise until "60.00" appears.

The flickering frequency is the set frequency.

You need not press .

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 142 143

No comments

Mitsubishi Electric F700 Instruction Manual Page 41