Mitsubishi Electric F700 Instruction Manual download pdf (Page 46)

DRIVE THE MOTOR

Operation by the start command from the

operation panel (PU operation mode)

3.5.5 Perform frequency setting by analog (current input)

[Connection diagram]

POINT

· Use / to give a start command.

· Turn the AU signal on.

· Pr. 79 Operation mode selection must be set to "4" (external/PU combined operation mode 2)

Three-phase

AC power supply

Moto

5(-)

4(+)

Inverter

R/L1

S/L2

T/L3

U signal

FR-DU07

Output of the

adjustment meter

(4 to 20mADC)

CAUTION

When both the forward switch and reverse

switch turn on, the inverter will not start.

Also, if both switch turn on while running,

the inverter stops.

Flickering

( )

The parameter number

read previously appears.

DisplayOperation

Start

Check that the terminal 4 input selection signal

(AU) is on.

Press the start switch (or ).

FWD or REV of operation status indication flickers.

Mode/monitor check

Press twice to choose the monitor/frequency

monitor.

Screen at powering on

The monitor display appears.

Press to choose the parameter setting mode.

Turn until (

Pr. 79) appears.

Press to read the currently set value.

" "(initial value) appears.

Turn clockwise to change it to the setting

value of " ".

Press to set.

Flicker ··· Parameter setting complete!!

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 142 143

Comments to this Manuals

No comments

Mitsubishi Electric F700 Instruction Manual Page 46

Comments to this Manuals

Related products and manuals for Power adapters & inverters Mitsubishi Electric F700